I'm removing my pool heater. We're selling the house soon and we don't want to invest in a new heater so I need to connect the in and out water tubes that used to connect to the heater. Ideally, you would have two elbow pieces with a 3 3/8 inch threaded end to connect to my system. then I would glue a bridge tube between the two elbows. I can't seem to find any parts with which to do this. can you help me?
removing pool heater
- 1.2K Views
- Last Post 27 June 2017
Service
posted this
27 June 2017
Hi Bobodette,
Could you post a few photos of the area in question from your pool heater plumbing? This would help us determine the proper parts. Also if you can find any digital writing on the pipe that says 1.5" or 2" that would be helpful.
Bobodette
posted this
27 June 2017
forget it - we're bying a new one - too old for cold water
