Removed old motor from pump (Challenger PAC-FAB) took off seal plate and mounting plate to expose defuser. Attached channel locks to shaft end and attempted to rotate defuser to remove it. No luck. Even used a pipe wrench which caused a crack in the defuser. How in the world do I get it off?
Removing old impeller
- 182 Views
- Last Post 10 May 2017
dama70
posted this
09 May 2017
- Last edited 10 May 2017
Service
posted this
10 May 2017
Hi dama70,
I would check to see if there is an impeller screw threaded into the center of the motor shaft securing the impeller to the shaft of the motor? Could you send us a few photo's, as photo's really help.
Thank You
Patrick