I removed the previous motor and took photos to reference. The removal of the old pump and putting the new motor was a breeze... until the wiring. I have two black wires and one green. The green is on the ground while the "hot" black is connected to L1 and the non-hot black wire is connected to L2. When I turn on the power, the LED for the unit flashes green for 1-2 seconds and then off. I tried swapping this configuration to no avail. I'm now back to the hot being on L1 and non-hot on L2. Has anyone had this issue before? Any thoughts or recommendations? I believe it's a 220/230 since it's a double breaker.
Wiring the B2983T
- 200 Views
- Last Post 14 June 2017
gmfurman
posted this
10 June 2017
Service
posted this
14 June 2017
Hi gmfurman,
We put together this Guide on How to Wire Digital Dual Speed Motor which should walk you through the process of the wiring.
Thank You
Patrick
