My pool salt cell recently failed after 5 years of use. (no chlorine produced, and error msg on system) Problem was it convinced me that my salt was low and I added too much. I did not realize my blunder until I installed the new cell. I removed water, bringing my level from 4700PPM to 3800PPM (using new salt test strips) Here’s my question: My Aqua Rite System now says salt is 1900PPM, but also says “salt levels too high/voltage too high”. My test strips say 3800PPM & store tests say the same. Will the cell kick in when I get levels to 3500PPM or does cell rely on the Aqua Rite reading (which is clearly off)?
Thinking I may have an Aqua Rite problem instead of a cell problem ..