I would like to know which automation system I should buy and which actuator valves I should buy.
Here is my setup: Pool with Spa
Pool Pump: I have his variable speed motor ECM16SQU I purhcased from Inyol
http://www.inyopools.com/Products/00200017074679.htm
The manual states external digital control and shows RS-485 interface
Booster pump: Polaris single speed PB3-60
Valves: They are older Jandy Neverlube diverters 3-port, manual
Heater: Old heater with manual on/off switch, but I plan to buy a Raypak in the near future. So I want to control old one and switch to new one later
Solar: I do not have solar now, but will add. So I can buy any valves or sensors
Salt Chlorinator: I have an old one I need replacing, so can be any model that works with automation. I want the biggest one, pool is 25K gallons.
Modes:
Standard Pool Mode: VS pump low RPM, Valve for drain set for pool, return valve set to 90% pool. 10% spa (a way to set angle of valve), solar valve off
Standard pool mode with polairs booster on: Same as above but turn on Polaris booster pump
Standard pool mode with solar: same as above but solar temp sensor, turn on solar valve as needed based on temp. May need to increase RPM of pump
Standard pool mode with solar with Rayak heater: Turn on heater to heat pool to desired temp
Spa mode: changes valves for Spa and turn on heater. Run pump and higher RPM
Light: I have one light. Turn light on/off. This is optional and not a requirment.
I guess I would need a system that has relays and RS-485 control. The problem I am having is that I cannot get much info about compatibility with the motor for RPM control.
In summary: What is recommended system and what valves should I buy?