Leonard Pressley

  • 19 Views
  • Last Post 11 May 2021
Wayne0604 posted this 11 May 2021

I am needing Top Plates for 18x33x52 Oval Tuscany Conquest Pool. I have check the dimensions of mine and i have 2 sizes. One is 7 1/4" which I need 6 of and your PN# 21134 and the other is 6 3/8" which I need 7 of and your PN# 20668A. These are metal. Do you have these available in resin and what is PN and cost for each?. 

Service posted this 11 May 2021

Hi Wayne, We'd be glad to assist you. Could you post a few photos, please supply a close-up photo of your top cap, top rail, and a wide shot showing the pattern of your pool wall. Also if you can pull any part #'s from the current top caps, normally this is stamped into the underside of the top cap so you may need to remove the top cap. If you have any documentation from the pool like the owner's manual then if you could send us the page showing the parts diagram then that is always helpful as well. To supply this information and photos follow the instructions below...

Thank You

Patrick

www.inyopools.com

Close