What is the correct pump seal kit for Century UST1102 ?
Seal kit fit UST1102 pump
- 1.4K Views
- Last Post 15 August 2022
John1951
posted this
08 April 2022
poolaustin
posted this
15 August 2022
Not so familiar but you can try POOL PUMP SHAFT SEAL. Shaft Seals prevent water from leaking along the motor shaft, just behind where it connects to the impeller. The motor shaft goes through the seal plate, or the bracket that connects to the pump.
Patrickk
posted this
05 August 2022
- Last edited 05 August 2022
My previous Century 1 hp motor lasted several years, so I replaced it with a new one that was identical. The pump assembly's gaskets were worn and began to leak slightly, causing the front bearing on the pump motor to wear out. The motor is very powerful, with more than enough power to supply a steady stream of water to our inground pool and the rooftop solar heating array. I'll keep updating after a month.
davidson02
posted this
14 April 2022
Great. I definitely learned something new about seal kits!
InyoRich
posted this
11 April 2022
It is our pleasure to help! Let us know if you need anything else.
- Liked by
-
John1951
posted this
11 April 2022
Thank you for your guidance !
InyoRich
posted this
11 April 2022
That is good enough - that SP1600M is unique to a Hayward Super Pump, so the GOKIT3 Tune-Up Kit is the one you will need; get the GOKIT3SALT Tune-Up Kit if you have a saltwater pool. It has a heavier-duty motor shaft seal in it.
John1951
posted this
11 April 2022
The labels are no longer on the housing. Part numbers that I have found on the basket which is SP-1600-M also the part number on the cover is SP-1600-0. I'm not sure if you can back into it for the correct kit.
