Pump motor is corroding at the back end, ate a hole in of housing. Not sure what's causing it or how to slow it?
Pump corrosion
- 448 Views
- Last Post 25 September 2019
RonRiedy
posted this
24 September 2019
- Last edited 25 September 2019
dave1436
posted this
24 September 2019
i have been having the same problem. I bought a VS motor the Vgreen works great but now looks like this after 5 month of duty. not sure what to do now, pump is only 5 months old.replaced a super pump after 4 years looked the same.
InyoRob
posted this
25 September 2019
Based on the picture, my guess would be that the shaft seal was installed incorrectly. There must have been some leaking between the plate and the motor. Any leaking should be addressed immediately by replacing the shaft seal or readjusting it if it's new.
