I ordered Century motor and tune up kit. After install, there is a leak where the motor is bolted into the plate. What else could it be?
Leak at motor/plate after new motor installed
- 563 Views
- Last Post 31 August 2021
InyoRob
posted this
31 August 2021
It's possible that the shaft seal was not sitting flush with the seal plate. There could be a small crack in the seal plate.
The first thing I'd try is reseating the shaft seal and make sure it is installed in the correct orientation.
?t=464
StephHill
posted this
31 August 2021
Thank you! I'll check that out. I did order a new seal plate just in case. I'll try that!