I ordered Century motor and tune up kit. After install, there is a leak where the motor is bolted into the plate. What else could it be?
Leak at motor/plate after new motor installed
- 563 Views
- Last Post 31 August 2021
StephHill
posted this
31 August 2021
Thank you! I'll check that out. I did order a new seal plate just in case. I'll try that!
InyoRob
posted this
31 August 2021
It's possible that the shaft seal was not sitting flush with the seal plate. There could be a small crack in the seal plate.
The first thing I'd try is reseating the shaft seal and make sure it is installed in the correct orientation.
?t=464