Hey all, I have a SP2603VSP. My house is going to be running off generator for about 4 hours tomorrow during utility maintenance. It will be about 36 degrees. I don't want my pump to kick on while running off generator. If I use the stop function on the stop/resume button, will that stop it/shut it off to the point where freeze protect wouldn't kick in, or do I have to completely cut the power to it?
Hayward SP2603VSP freeze protect/stop function
- 335 Views
- Last Post 19 December 2022
MatthewKitchin
posted this
19 December 2022
- Last edited 19 December 2022
MatthewKitchin
posted this
19 December 2022
Thanks. I didn't think about it resetting due to the downtime.
InyoRich
posted this
19 December 2022
Hi Matthew, I would recommend cutting power to the pump at its breaker to be 100% certain it will not turn on. I assume the power will kick off completely for at least a few seconds before the generator kicks in, so anything you do on the control panel might be "forgotten" by the time the generator transfer switch powers your house up again.