The display on my Aqua Plus indiacated "no voltage" to T-Cell, chlorinator off. The entire system, Aqua Plus and the T-Cell is 8 years old. I figuared that the T-Cell was bad and order a new one from you. Just recieved it today and put it into service. I now get a "High Salt/high Amps" message on the control panel. I followed the procedure in the manual to lower the water level and then add addition water ( over 14 inches). I'm still receiving the "high salt/high amps" message, but now also recieving "Low Salt" message??? Did I get a Bad T-Cell or is the Board bad? How do I trouble shoot that?