Back in 2019 I installed a Purline T15 salt cell along with a new Aqua Rite PC board. I'm pretty sure the salt cell is working fine. Salt reading on the Aqua Rite display matches the salt reading I get with a Taylor salt test kit = 3200. However, when my pump turns on each morning the Aqua Rite display shows a low salt error with the inspect cell and no flow lights on. I have to manually switch the Aqua Rite from Auto to Off and then back to Auto again to get the system working again. It works fine the whole time until the next day. Seem like the issue only happens on startup.
As a side note, I recently had a variable speed pump installed and it seems like this low salt issue starting happening around the same time. Not sure if the two things are related or not. Finally, I can no longer calibrate the salt level by going from Auto to Off and then back to Auto again. The unit clicks off and then clicks on immediately. There's no 5 to 10 second lag anymore between clicks.
Anybody have any ideas ?
Thanks,
ALEX